Power supply is at least 2 times greater than motor power
DC 24-36V or AC24V 10% ,50Hz/60Hz
Rated Duty Cycle:
After-sales Service Provided:
Overseas service center available
DC24V dc motor
The partial pressure ratio:
The cutting torch increases speed:
Set the arc pressure range:
1000 Piece/Pieces per Month Arc Voltage Torch Height Controller
Packaging & Delivery
Arc Voltage Torch Height Controller:Packaging of Carton
Shipped in 2-5 days after payment
Arc Voltage Torch Height Controller
1. The new xpthc-100v adopts a more concise setting method, which can be set directly in the operation panel (P0 -P9 parameter), while retaining the quick setting knob of the old style.If you need to restore the default factory parameters, press "AUTO" and "MENU" button at the same time, then click the "IHS" button.
2. The wiring mode of the "motor interface" of the xpthc-100v regulator is consistent with the old one, adding the limit logic modification setting parameters P6 and the current limit state display.The limit logic is normally closed and valid, consistent with the old one.
3. The "proximity switch positioning interface" of xpthc-100v is consistent with the old style, but it is not necessary to set the model of the proximity switch within the internal jumper, just by modifying the P9 parameters of the panel.
4. Xpthc-100v's "TO CNC" interface 1, 2, 3, 4, 5, 8 and previous functions are the same, but the 6 is an arc feedback output, which can be directly connected TO the CNC arc feedback input port;The 7th foot is the "collision" outlet, which can be directly connected to the CNC collision input port.The external dynamic perforation wiring of the foot of the old model 9 and 10 is cancelled due to the internal dynamic perforation function of the regulating device.
5. Xpthc-100v protective hat positioning port wiring method is basically consistent with the old style, but the "high voltage isolator" is added to realize the protection hat positioning of hf arc plasma.The xpthc-100v also increases the nozzle-location function, and the red location cable of the "high voltage isolator" can be directly attached to the arc of the plasma cutting torch (no need to be attached to the "nozzles").Under the protection hat positioning mode and the nozzle positioning mode, it has the underwater positioning function, which needs to change the "P0" parameter to 1, and the high voltage isolator should be installed on the side of the plasma cutting torch.
6. The power interface of the xpthc-100v is consistent with the old style, which can be powered by DC24V or AC24V.
7. XPTHC - 100 - v points linking piece installation size and older, but the points of the platen press than 50:1 instead (because of adopting 50:1 higher control precision), and at the same time points linking piece by AC220V modification for the AC power supply voltage or DC24V, can directly use the power block, please attention!Adjustable clamp connection block and points, four core navigation plug connection method can according to the old method, but it is best to refer to the instruction to use the new wiring method, anti-interference performance is stronger, please refer to clamp the wiring diagram.
If you replace the old xpthc-100 with the xpthc-100v, note the following:
1. The xpthc-100v is compatible with all interfaces of the old style. The original line remains unchanged and can be connected directly.
2. Pay attention "TO CNC" interface is 6 foot arc feedback, if your old version is used as feedback arc, 6, 7 feet and 6 feet is directly TO CNC arc feedback, so the line without making any changes.Please refer to the wiring diagram of this manual.